Model No: Anthem Statement P2 amplifier

Availability: 2

Category: Pre-Owned Equipment

Anthem Statement P2 amplifier

  • $3,800.00

GENERAL

Inputs2 Single-Ended, 2 Balanced, 1 Relay Trigger (3.5 mm Mono Jack)Outputs2 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5 mm Mono Jack)THD+N (225 W into 8 Ω)0.0007% at 1 kHz, 0.008% at 20 kHzIMD0.00019% (CCIF, 325 W into 8 Ω)POWER BANDWIDTH10 Hz to 150 kHz
(+0 -3 dB, 325 W into 8 Ω)FREQUENCY RESPONSE20 Hz to 20 kHz (+0 -0.15 dB),
5 Hz to 100 kHz (+0 -2 dB)INPUT SENSITIVITY (RCA and XLR 0 dB inputs)1 Vrms in for 28.3 Vrms out
(100 W into 8 Ω)INPUT IMPEDANCE18 kΩ (RCA), 22 kΩ (XLR)DAMPING FACTOR>600 at 20 Hz, 400 at 1 kHz (ref. 8 Ω)S/N RATIO125 dB, A-weighted (ref. 325 W)CROSSTALK (between any two channels)-140 dB (20 Hz), -80 dB (20 kHz)VOLTAGE GAIN29 dBSLEW RATE40 V/µsSWITCHESFront PanelPower (On/Off)Rear PanelOn/Off Modes (Trigger, Manual, Auto), Inputs (RCA, XLR, XLR -6dB)POWER OUTPUT
(Per channel, continuous RMS, 20 Hz to 20 kHz, <0.1% THD, one or all channels driven.)
Impedance
# of Channels Driven1All1All1All
325 W325 W500 W500 W675 W675 W
Statement P2 and P5 amplifiers are stable into any impedance down to a short circuit at full output.POWER REQUIREMENTSSUPPLY VOLTAGE105 to 130 V, 60 HzPOWER CONSUMPTION1800 WDIMENSIONSHeight9-3/8 inches (23.8 cm) including feetWidthFaceplate 19-1/4 inches (49 cm)
Chassis 17-1/4 inches (43.8 cm)Depth22-1/2 inches (57.2 cm) including handlesWeight (unpacked)75 lb (34 kg)


GENERAL

Inputs2 Single-Ended, 2 Balanced, 1 Relay Trigger (3.5 mm Mono Jack)Outputs2 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5 mm Mono Jack)THD+N (225 W into 8 Ω)0.0007% at 1 kHz, 0.008% at 20 kHzIMD0.00019% (CCIF, 325 W into 8 Ω)POWER BANDWIDTH10 Hz to 150 kHz
(+0 -3 dB, 325 W into 8 Ω)FREQUENCY RESPONSE20 Hz to 20 kHz (+0 -0.15 dB),
5 Hz to 100 kHz (+0 -2 dB)INPUT SENSITIVITY (RCA and XLR 0 dB inputs)1 Vrms in for 28.3 Vrms out
(100 W into 8 Ω)INPUT IMPEDANCE18 kΩ (RCA), 22 kΩ (XLR)DAMPING FACTOR>600 at 20 Hz, 400 at 1 kHz (ref. 8 Ω)S/N RATIO125 dB, A-weighted (ref. 325 W)CROSSTALK (between any two channels)-140 dB (20 Hz), -80 dB (20 kHz)VOLTAGE GAIN29 dBSLEW RATE40 V/µsSWITCHESFront PanelPower (On/Off)Rear PanelOn/Off Modes (Trigger, Manual, Auto), Inputs (RCA, XLR, XLR -6dB)POWER OUTPUT
(Per channel, continuous RMS, 20 Hz to 20 kHz, <0.1% THD, one or all channels driven.)
Impedance
# of Channels Driven1All1All1All
325 W325 W500 W500 W675 W675 W
Statement P2 and P5 amplifiers are stable into any impedance down to a short circuit at full output.POWER REQUIREMENTSSUPPLY VOLTAGE105 to 130 V, 60 HzPOWER CONSUMPTION1800 WDIMENSIONSHeight9-3/8 inches (23.8 cm) including feetWidthFaceplate 19-1/4 inches (49 cm)
Chassis 17-1/4 inches (43.8 cm)Depth22-1/2 inches (57.2 cm) including handlesWeight (unpacked)75 lb (34 kg)

Write a review

Note: HTML is not translated!
    Bad           Good